The Technology Limits for Stratified Injection of Polymer Flooding

Publisher： Trans Tech Publications

E-ISSN： 1662-8985|2015|1094|433-436

ISSN： 1022-6680

Source： Advanced Materials Research, Vol.2015, Iss.1094, 2015-04, pp. : 433-436

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

High Concentration Polymer Flooding Injection Time Optimization of Sub-Layer Reservoir

By  

Advanced Materials Research, Vol. 2014, Iss. 1081, 2015-02 ,pp. : 237-240

Trans Tech Publications

Access to resources Recommend Favorite

Artificial Gas Cap Flooding Technology of Complex Fault Block Reservoir

By  

Advanced Materials Research, Vol. 2014, Iss. 1073, 2015-01 ,pp. : 2272-2275

Trans Tech Publications

Access to resources Recommend Favorite

Injection moulding of self-reinforcing polymers and polymer blends

By Lekakou C.   Cowley J.   Dickinson C.E.  

Journal of Materials Science, Vol. 32, Iss. 5, 1997-05 ,pp. : 1319-1324

Springer Publishing Company

Access to resources Recommend Favorite

Thermal conductivity of metal powder-polymer feedstock for powder injection moulding

By Kowalski L.   Duszczyk J.   Katgerman L.  

Journal of Materials Science, Vol. 34, Iss. 1, 1999-04 ,pp. : 1-5

Springer Publishing Company

Access to resources Recommend Favorite

Electrical properties of polymer/metal interface in polymer light-emitting devices: electron injection barrier suppression

By Olivati C.   Carvalho A.   Balogh D.   Faria R.  

Journal of Materials Science, Vol. 41, Iss. 10, 2006-05 ,pp. : 2767-2770

Springer Publishing Company

Access to resources Recommend Favorite