A New Approach to Determining the Bending Moment in Tube Forming

E-ISSN： 1662-8985|2015|1127|31-37

ISSN： 1022-6680

Source： Advanced Materials Research, Vol.2015, Iss.1127, 2015-11, pp. : 31-37

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Rotational factor using bending moment approach under elasto-plastic situation--II. Crack 3PB geometry

By Kumar A.N. Bhattacharya S.

Engineering Fracture Mechanics, Vol. 50, Iss. 4, 1995-03 ,pp. : 507-517

Elsevier

Access to resources Recommend Favorite

Rotational factor using bending moment approach under elasto-plastic situation--I. Notch 3PB geometry

By Bhattacharya S. Kumar A.N.

Engineering Fracture Mechanics, Vol. 50, Iss. 4, 1995-03 ,pp. : 493-505

Elsevier

Access to resources Recommend Favorite

Development of the Bending Actuator with Nafion-Pt IPMC Tube

Advanced Materials Research, Vol. 2015, Iss. 1119, 2015-08 ,pp. : 251-257

Trans Tech Publications

Access to resources Recommend Favorite

GFRP Bar: Determining Tensile Strength with Bending Test

Advanced Materials Research, Vol. 2015, Iss. 1083, 2015-02 ,pp. : 90-96

Trans Tech Publications

Access to resources Recommend Favorite

The Effect of Composite Patches on the Failure of Adhesively-Bonded Joints Under Bending Moment

By Akpinar Salih

Applied Composite Materials, Vol. 20, Iss. 6, 2013-12 ,pp. : 1289-1304

Springer Publishing Company

Access to resources Recommend Favorite