Preliminary Study: The Effect of Tool Engagement and Cutting Speed on Cutting Temperature during Contour Tool Path Strategy

Publisher： Trans Tech Publications

E-ISSN： 1662-8985|2015|1115|86-89

ISSN： 1022-6680

Source： Advanced Materials Research, Vol.2015, Iss.1115, 2015-08, pp. : 86-89

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Cutting Temperature Behaviours in End Milling of Pocket by Applying Contour-In Tool Path Strategy

By  

Advanced Materials Research, Vol. 2015, Iss. 1115, 2015-08 ,pp. : 47-50

Trans Tech Publications

Access to resources Recommend Favorite

Cutting tool materials for high speed machining

By Zhangiang Liu   Xing Ai  

Progress in Natural Science, Vol. 15, Iss. 9, 2005-09 ,pp. : 777-783

Taylor & Francis Ltd

Access to resources Recommend Favorite

Effect of Cutting Parameters on Tool Life: Case Study Twist Drill

By  

Advanced Materials Research, Vol. 2015, Iss. 1101, 2015-05 ,pp. : 397-401

Trans Tech Publications

Access to resources Recommend Favorite

Machining of SiCp/Al Composites: Effect of Tool Corner Radius on Residual Stresses, Cutting Force and Temperature

By  

Advanced Materials Research, Vol. 2017, Iss. 1142, 2017-02 ,pp. : 265-270

Trans Tech Publications

Access to resources Recommend Favorite

Measurement of the Temperature Distribution at the Tool-Chip Interface by Using a Cutting Tool with Seven Pairs of Built-In Micro Cu/Ni Thermocouples

By  

Advanced Materials Research, Vol. 2015, Iss. 806, 2015-12 ,pp. : 586-591

Trans Tech Publications

Access to resources Recommend Favorite