FEA-Based Optimisation of a Clinching Process with a Closed Single-Part Die Aimed at Damage Minimization in CR240BH-AlSi10MnMg Joints

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|651|1487-1492

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.651, 2015-08, pp. : 1487-1492

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Microstructure and Mechanical Properties of a New Secondary AlSi10MnMg(Fe) Alloy for Ductile High Pressure Die Casting Parts for the Automotive Industry

By  

Key Engineering Materials, Vol. 2016, Iss. 710, 2016-10 ,pp. : 244-249

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Cr and Mn Addition and Heat Treatment on the Corrosion Behaviour of an AlSi3Mg Alloy

By  

Key Engineering Materials, Vol. 2017, Iss. 754, 2017-10 ,pp. : 11-14

Trans Tech Publications

Access to resources Recommend Favorite

Effects of homogenisation conditions on semisolid microstructures of Al–Mg–Si–Mn alloys produced by D-SSF process

By Eidhed W.   Tezuka H.   Sato T.  

International Journal of Cast Metals Research, Vol. 21, Iss. 1-4, 2008-08 ,pp. : 168-173

Maney Publishing

Access to resources Recommend Favorite

Fatigue failures in low pressure die cast AlSi10Mg cylinder heads

By Birol Y.   Ebrinc A. A.  

International Journal of Cast Metals Research, Vol. 21, Iss. 6, 2008-12 ,pp. : 408-415

Maney Publishing

Access to resources Recommend Favorite

Process model for welding of Al–Mg–Si extrusions Part 1: Precipitate stability

By Myhr O. R.   Grong Ø.   Klokkehaug S.   Fjœr H. G.   Kluken A. O.  

Science and Technology of Welding & Joining, Vol. 2, Iss. 6, 1997-12 ,pp. : 245-253

Maney Publishing

Access to resources Recommend Favorite