Experimental and Numerical Determination of the Required Initial Sheet Width in Die Bending

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|639|147-154

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.639, 2015-04, pp. : 147-154

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

First Experimental and Numerical Study on the Use of Sheet Metal Die Covers for Wear Protection in Closed-Die Forging

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 266-271

Trans Tech Publications

Access to resources Recommend Favorite

Die-Bending of Adhesively Bonded Sheet Metals

By  

Key Engineering Materials, Vol. 2014, Iss. 626, 2015-01 ,pp. : 103-108

Trans Tech Publications

Access to resources Recommend Favorite

Numerical – Experimental Correlation of Sheet Hydroformed Component

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1140-1145

Trans Tech Publications

Access to resources Recommend Favorite

Numerical and Experimental Investigation into Hot Forming of Ultra High Strength Steel Sheet

By Liu Hongsheng   Liu Wei   Bao Jun   Xing Zhongwen   Song Baoyu   Lei Chengxi  

Journal of Materials Engineering and Performance, Vol. 20, Iss. 1, 2011-02 ,pp. : 1-10

Springer Publishing Company

Access to resources Recommend Favorite

Numerical Heat Treatment Modelling of Fine Blanked Sheet Metal and Experimental Validation

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 1531-1536

Trans Tech Publications

Access to resources Recommend Favorite