Fabrication of Nanoporous Copper Ribbons through Dealloying of Al-Cu-Mn Alloys

E-ISSN： 1662-9795|2014|636|111-114

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2014, Iss.636, 2015-02, pp. : 111-114

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Well-Ordered Nanoporous Copper Fabricated by Dealloying Cu-Mn and its Characterizations

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 662-668

Trans Tech Publications

Access to resources Recommend Favorite

Study of Al-Cu-Mn and Al-Mg-Si Alloys Thin Sheets Weldability

Key Engineering Materials, Vol. 2017, Iss. 746, 2017-08 ,pp. : 22-28

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Dealloying Conditions on Nanoporous Surface of Cu-Zn Alloy

Key Engineering Materials, Vol. 2017, Iss. 728, 2017-03 ,pp. : 181-186

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure, fabrication and properties of quasicrystalline Al-Cu-Fe alloys: a review

By Huttunen-Saarivirta E.

Journal of Alloys and Compounds, Vol. 363, Iss. 1, 2004-01 ,pp. : 154-178

Elsevier

Access to resources Recommend Favorite

Tensile anisotropy in Cu-Ni-Mn-Sn-Al alloys

By Han Seungzeon Sohn Keunyong Kim Changjoo Kim Sangshik

Metallurgical and Materials Transactions A, Vol. 35, Iss. 2, 2004-02 ,pp. : 465-469

Springer Publishing Company

Access to resources Recommend Favorite