A Comparison of Mechanical Properties of Lumbar Bilateral Implants Manufactured by Additive and Conventional Technologies

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2014|635|139-142

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2014, Iss.635, 2015-02, pp. : 139-142

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Mechanical Properties of Additive Manufactured Ti-6Al-4V Using Wire and Powder Based Processes

By  

IOP Conference Series: Materials Science and Engineering, Vol. 26, Iss. 1, 2011-12 ,pp. : 27-36

IOP Publishing

Access to resources Recommend Favorite

Mechanical Properties of Additive Manufactured Complex Matrix Three-Component Carbon Fiber Reinforced Composites

By  

Key Engineering Materials, Vol. 2016, Iss. 712, 2016-10 ,pp. : 232-236

Trans Tech Publications

Access to resources Recommend Favorite

Mechanical Testing of Additive Manufactured Metal Parts

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 713-718

Trans Tech Publications

Access to resources Recommend Favorite

Comparison of mechanical and microstructural properties of conventional and severe plastic deformation processes

By  

IOP Conference Series: Materials Science and Engineering, Vol. 63, Iss. 1, 2014-08 ,pp. : 447-455

IOP Publishing

Access to resources Recommend Favorite

Accuracy of Additive Manufactured Parts

By  

Key Engineering Materials, Vol. 2015, Iss. 661, 2015-10 ,pp. : 113-118

Trans Tech Publications

Access to resources Recommend Favorite