Theoretical Analysis about Off-Axis Parabolic Surface Machining under Two Different Accurate Spiral Tool Paths

E-ISSN： 1662-9795|2014|625|267-273

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2014, Iss.625, 2014-10, pp. : 267-273

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Validation of strain invariant failure analysis in an open hole off-axis specimen

By Mendoza Jasso Alvaro Goodsell Johnathan Pipes R. Koslowski Marisol

JOM, Vol. 63, Iss. 9, 2011-09 ,pp. : 43-48

Springer Publishing Company

Access to resources Recommend Favorite

Tribological Behavior of Different Tool Steels and Surface Properties under Hot Stamping Conditions

Key Engineering Materials, Vol. 2018, Iss. 767, 2018-06 ,pp. : 212-219

Trans Tech Publications

Access to resources Recommend Favorite

CYCLIC DAMAGE CHARACTERIZATION OF AN OFF-AXIS UNIDIRECTIONAL GRAPHITE BISMALEIMIDE COMPOSITE

By CAIN K.J. GLINKA G. PLUMTREE A.

Canadian Metallurgical Quarterly, Vol. 45, Iss. 4, 2006-01 ,pp. : 433-440

Maney Publishing

Access to resources Recommend Favorite

The Analysis of the Machining Influence of the Surface Layer on Durability

Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. : 293-298

Trans Tech Publications

Access to resources Recommend Favorite

High Speed Machining of Difficult-to-Machine Materials under Different Lubrication Conditions

Key Engineering Materials, Vol. 2014, Iss. 625, 2014-10 ,pp. : 60-65

Trans Tech Publications

Access to resources Recommend Favorite