Comparison of Three Methods for Material Hardening Parameter Identification under Cyclic Tension-Compression Loadings: Roll Levelling Case Study

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2015|651|957-962

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.651, 2015-08, pp. : 957-962

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Cyclic Test of DP600 Steel under Tension-Compression Load for Different Pre-Strain Levels

By  

Key Engineering Materials, Vol. 2014, Iss. 635, 2015-02 ,pp. : 71-74

Trans Tech Publications

Access to resources Recommend Favorite

Comparison of 15Mo3 Strain Curves Obtained for Strain-Controlled Cyclic Bending and Tension-Compression Tests

By  

Solid State Phenomena, Vol. 2016, Iss. 250, 2016-06 ,pp. : 85-93

Trans Tech Publications

Access to resources Recommend Favorite

Research on Material Fatigue Test of Steel Fiber Reinforced Concrete under Tension and Compression Loading

By  

Key Engineering Materials, Vol. 2017, Iss. 730, 2017-03 ,pp. : 353-357

Trans Tech Publications

Access to resources Recommend Favorite

Quantitative characterization of three-dimensional damage evolution in a wrought Al-alloy under tension and compression

By Agarwal H.   Gokhale A.   Graham S.   Horstemeyer M.  

Metallurgical and Materials Transactions A, Vol. 33, Iss. 8, 2002-08 ,pp. : 2599-2606

Springer Publishing Company

Access to resources Recommend Favorite

Work-Hardening Behavior of Cold Rolled Interstitial-Free Steel Sheet and Dual Phase High Strength Steel Sheets Subjected to Two-Stage, Coaxial and Non-Coaxial Tension/Compression

By  

Key Engineering Materials, Vol. 2015, Iss. 651, 2015-08 ,pp. : 83-88

Trans Tech Publications

Access to resources Recommend Favorite