Influence of the V-Notch Opening Angle on Critical Applied Force Values for the Crack Initiation from the Sharp V-Notch

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2014|627|165-168

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2014, Iss.627, 2015-01, pp. : 165-168

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Bending Singularity at the Apex of V-Notch in an Anisotropic Thick Plate

By  

Key Engineering Materials, Vol. 2017, Iss. 735, 2017-06 ,pp. : 95-99

Trans Tech Publications

Access to resources Recommend Favorite

Charpy V-notch properties and microstructures of narrow gap ferritic welds of a quenched and tempered steel plate

By Powell G.   Herfurth G.  

Metallurgical and Materials Transactions A, Vol. 29, Iss. 11, 1998-11 ,pp. : 2775-2784

Springer Publishing Company

Access to resources Recommend Favorite

Analysis of the State of Stress at the V-Hole Ended Notch for Mode II

By  

Solid State Phenomena, Vol. 2016, Iss. 250, 2016-06 ,pp. : 29-36

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of Crack Generation in a Notch during Diameter-Enlargement Working Method Processing

By  

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 473-478

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of fatigue crack initiation in Ti-6Al-4V during tensile-tensile fatigue

By Ivanova Svetlana   Biederman Ronald   Sisson Richard  

Journal of Materials Engineering and Performance, Vol. 11, Iss. 2, 2002-04 ,pp. : 226-231

Springer Publishing Company

Access to resources Recommend Favorite