Air Jet Assisted End Milling of Titanium Alloy Ti-6Al-4V ELI at High Cutting Speed

E-ISSN： 1662-9795|2015|656|168-173

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.656, 2015-08, pp. : 168-173

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Finite Element Deformation Analysis of Long Thin Cantilever Shape Parts in High Speed Ball End Milling of Titanium Alloy Ti-6Al-4V with PCD Tools at Various Tool Inclination Angles

Key Engineering Materials, Vol. 2016, Iss. 693, 2016-06 ,pp. : 1038-1045

Trans Tech Publications

Access to resources Recommend Favorite

Influence of damping coefficient from permanent magnets on chatter formation during end milling of titanium alloy (Ti-6Al-4V)

IOP Conference Series: Materials Science and Engineering, Vol. 100, Iss. 1, 2015-12 ,pp. : 521-529

IOP Publishing

Access to resources Recommend Favorite

Effects on Surface Integrity of Ti6Al4V in High Speed Milling

Key Engineering Materials, Vol. 2017, Iss. 737, 2017-07 ,pp. : 156-161

Trans Tech Publications

Access to resources Recommend Favorite

Determination of FLD for Ti-6Al-4V Titanium Alloy Sheet

Key Engineering Materials, Vol. 2016, Iss. 687, 2016-05 ,pp. : 171-178

Trans Tech Publications

Access to resources Recommend Favorite

Effect of high-temperature hydrogen treatment on the microstructure and properties of titanium alloy Ti-6Al-4V

IOP Conference Series: Materials Science and Engineering, Vol. 22, Iss. 1, 2011-05 ,pp. : 67-77

IOP Publishing

Access to resources Recommend Favorite