Effects of Cutting Fluid Application in the Performance of the Nimomic 80A Turning

E-ISSN： 1662-9795|2015|656|243-250

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.656, 2015-08, pp. : 243-250

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effects of Cutting Speed, Cutting Fluid, and Carbon Fiber Orientation on Cutting of CFRP during Turning

Key Engineering Materials, Vol. 2017, Iss. 740, 2017-07 ,pp. : 133-138

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Cutting Fluid Conditions and Cutting Parameters on the Chip Form in Turning of Titanium and Steel Alloys

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 74-79

Trans Tech Publications

Access to resources Recommend Favorite

Application of Taguchi Method to Optimization of Cutting Force and Temperature during Turning of Difficult to Cut Materials

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 114-118

Trans Tech Publications

Access to resources Recommend Favorite

Specific Cutting Force in Turning of Sintered Nickel Alloy

Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. : 44-49

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Coolant Application Direction on the Cutting Performance of Ceramic Tool in High-Speed Air-Jet-Assisted Machining of Inconel 718

Key Engineering Materials, Vol. 2017, Iss. 749, 2017-09 ,pp. : 87-93

Trans Tech Publications

Access to resources Recommend Favorite