Evaluation of Machining Forces in Asymmetrical Face Milling of Cast Iron DIN GGG50

E-ISSN： 1662-9795|2015|656|271-276

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2015, Iss.656, 2015-08, pp. : 271-276

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Evaluation of Surface Roughness and Power Consumption in Machining FCD 450 Cast Iron using Coated and Uncoated Irregular Milling Tools

IOP Conference Series: Materials Science and Engineering, Vol. 114, Iss. 1, 2016-02 ,pp. : 162-169

IOP Publishing

Access to resources Recommend Favorite

Wear Characteristics of Coated Carbide Tools in the Face Milling of Ductile Cast Iron

Key Engineering Materials, Vol. 2017, Iss. 749, 2017-09 ,pp. : 178-184

Trans Tech Publications

Access to resources Recommend Favorite

Machining of Steel and Cast Iron Using Silicon Nitride Tools

By Tönshoff H. K. Bartsch S.

Canadian Metallurgical Quarterly, Vol. 28, Iss. 4, 1989-10 ,pp. : 353-359

Maney Publishing

Access to resources Recommend Favorite

Machining time in rough milling

By Othmani R. Bouzid W. Hbaieb M.

Materials Technology: Advanced Performance Materials, Vol. 23, Iss. 3, 2008-09 ,pp. : 169-173

Maney Publishing

Access to resources Recommend Favorite

EVALUATION OF LATENT HEAT OF SOLIDIFICATION OF GREY CAST IRON FROM COOLING CURVES

By ÇETIN A. KALKANLI A.

Canadian Metallurgical Quarterly, Vol. 44, Iss. 1, 2005-01 ,pp. : 1-5

Maney Publishing

Access to resources Recommend Favorite