Numerical prediction of flow induced fibers orientation in injection molded polymer composites

Publisher： IOP Publishing

E-ISSN： 1757-899X|100|1|540-546

ISSN： 1757-899X

Source： IOP Conference Series: Materials Science and Engineering, Vol.100, Iss.1, 2015-12, pp. : 540-546

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Injection Molded Aluminum-Polymer-Composites - Integral Lightweight Structures with Potential

By  

Key Engineering Materials, Vol. 2017, Iss. 742, 2017-08 ,pp. : 381-388

Trans Tech Publications

Access to resources Recommend Favorite

Warpage of injection-molded thermoplastics parts: Numerical simulation and experimental validation

By Guo Zhiying   Ruan Xueyu   Peng Yinghong   Li Dequn  

Journal of Materials Engineering and Performance, Vol. 11, Iss. 2, 2002-04 ,pp. : 138-144

Springer Publishing Company

Access to resources Recommend Favorite

Low-temperature baroplastic processing of graphene-based polymer composites by pressure-induced flow

By  

IOP Conference Series: Materials Science and Engineering, Vol. 62, Iss. 1, 2014-08 ,pp. : 136-143

IOP Publishing

Access to resources Recommend Favorite

Utilization of Surface-Modified Polymer and Glass Micro-Fibers as Reinforcement in Cement Composites

By  

Key Engineering Materials, Vol. 2018, Iss. 760, 2018-02 ,pp. : 225-230

Trans Tech Publications

Access to resources Recommend Favorite

Modeling and flow analysis of pure nylon polymer for injection molding process

By  

IOP Conference Series: Materials Science and Engineering, Vol. 114, Iss. 1, 2016-02 ,pp. : 400-406

IOP Publishing

Access to resources Recommend Favorite