Effect of cooling methods on hole quality in drilling of aluminium 6061-6T

Publisher： IOP Publishing

E-ISSN： 1757-899X|114|1|209-225

ISSN： 1757-899X

Source： IOP Conference Series: Materials Science and Engineering, Vol.114, Iss.1, 2016-02, pp. : 209-225

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Eccentricity Effect in the Hole-Drilling Residual Stress Measurement

By  

Defect and Diffusion Forum, Vol. 2018, Iss. 382, 2018-02 ,pp. : 208-212

Trans Tech Publications

Access to resources Recommend Favorite

Cooling rate effect on entrapment of short alumina fibres into aluminium alloy

By Gómez-García C.   Rubio E.     Castaño V. M.   Herrera A.  

International Journal of Cast Metals Research, Vol. 17, Iss. 6, 2004-12 ,pp. : 357-363

Maney Publishing

Access to resources Recommend Favorite

Burr Height as Quality Indicator in Single Shot Drilling of Stacked CFRP/Aluminium Composite

By  

Key Engineering Materials, Vol. 2017, Iss. 744, 2017-08 ,pp. : 327-331

Trans Tech Publications

Access to resources Recommend Favorite

The Effect of the Detonation Velocity in Explosively Welded Steel-Zirconium Bimetal on the Residual Stresses Determined by the Hole-Drilling Method

By  

Solid State Phenomena, Vol. 2014, Iss. 224, 2015-02 ,pp. : 181-186

Trans Tech Publications

Access to resources Recommend Favorite

The effect of welding parameters on surface quality of AA6351 aluminium alloy

By  

IOP Conference Series: Materials Science and Engineering, Vol. 100, Iss. 1, 2015-12 ,pp. : 315-319

IOP Publishing

Access to resources Recommend Favorite