Experimental Investigation of Heat Partition Ratio for the Cutting Tool at a Cutting Speed Ranging from 38 to 6500 m/min

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2016|874|450-456

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.874, 2016-11, pp. : 450-456

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Cutting Temperature and Cutting Forces Investigation Based on the Taguchi Design Method when High-Speed Milling of Titanium Matrix Composites with PCD Tool

By  

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 168-174

Trans Tech Publications

Access to resources Recommend Favorite

Experimental and Numerical Investigation of the Influence of Cutting Speed and Feed Rate on Forces in Turning of Steel

By  

Materials Science Forum, Vol. 2016, Iss. 862, 2016-09 ,pp. : 270-277

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Investigation of the Shear Cutting Behaviour of Sandwich Panels

By  

Materials Science Forum, Vol. 2015, Iss. 825, 2015-08 ,pp. : 433-440

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Cutting Speed on the Face Milling of CFRP Using a PCD Tool

By  

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 487-491

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of contact stresses and their influence on the physics of cutting of 45 steel by cutting tools of high-speed alloys

By Sagradyan A.  

Journal of Engineering Physics and Thermophysics, Vol. 78, Iss. 6, 2005-11 ,pp. : 1237-1240

Springer Publishing Company

Access to resources Recommend Favorite