Influence of heat treatments and Ca additions on the passivation behaviour of high‐pressure die cast AM50

E-ISSN： 1521-4176|66|12|1519-1528

ISSN： 0947-5117

Source： MATERIALS AND CORROSION/WERKSTOFFE UND KORROSION, Vol.66, Iss.12, 2015-12, pp. : 1519-1528

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

The Effects of Interfacial Heat Transfer Coefficient on the Microstructure of High-Pressure Die-Cast Magnesium Alloy AM60B

Materials Science Forum, Vol. 2016, Iss. 879, 2017-02 ,pp. : 1755-1759

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of the Solution Heat Treatment of Rheo-High Pressure Die Cast Al-Cu-Mg-Ag 2139 Alloy

Materials Science Forum, Vol. 2015, Iss. 828, 2015-09 ,pp. : 226-231

Trans Tech Publications

Access to resources Recommend Favorite

Annealing behaviour of nanocrystalline NiTi (50 at% Ni) alloy produced by high-pressure torsion

By Singh R.

Philosophical Magazine, Vol. 91, Iss. 22, 2011-08 ,pp. : 3079-3092

Taylor & Francis Ltd

Access to resources Recommend Favorite

Influence of heat treatment on the microstructural evolution of Al–3 wt.% Cu during high-pressure torsion

By Hohenwarter A. Faller M. Rashkova B. Pippan R.

Philosophical Magazine Letters, Vol. 94, Iss. 6, 2014-06 ,pp. : 342-350

Taylor & Francis Ltd

Access to resources Recommend Favorite

Influence of Initial Heat Treatment on the Microhardness Evolution of an Al-Mg-Sc Alloy Processed by High-Pressure Torsion

Materials Science Forum, Vol. 2016, Iss. 879, 2017-02 ,pp. : 1471-1476

Trans Tech Publications

Access to resources Recommend Favorite