Preliminary Investigation into the Suitability of 2xxx Alloys for Wire-Arc Additive Manufacturing

E-ISSN： 1662-9752|2016|877|611-616

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.877, 2017-01, pp. : 611-616

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Electrode phenomena investigation of wire arc spraying for preparation of Ti-Al intermetallic compounds

By Watanabe T. Sato T. Nezu A.

Thin Solid Films, Vol. 407, Iss. 1, 2002-03 ,pp. : 98-103

Elsevier

Access to resources Recommend Favorite

Cladding, Repair and Additive Manufacturing

LASER TECHNIK JOURNAL, Vol. 12, Iss. 1, 2015-01 ,pp. : 19-19

John Wiley & Sons Inc

Access to resources Recommend Favorite

Rheological Characterization of Aqueous ZrO₂-Suspension for Additive Manufacturing

Materials Science Forum, Vol. 2016, Iss. 881, 2017-02 ,pp. : 195-199

Trans Tech Publications

Access to resources Recommend Favorite

Corrosion of wire arc sprayed ZnMgAl

MATERIALS AND CORROSION/WERKSTOFFE UND KORROSION, Vol. 66, Iss. 6, 2015-06 ,pp. : 520-526

John Wiley & Sons Inc

Access to resources Recommend Favorite

Preparation of NiMoO 2 S 2 nanoparticle and investigation of its tribological behavior as additive in lubricating oils

By Ye P. Jiang X. Li S. Li S.

Wear, Vol. 253, Iss. 5, 2002-09 ,pp. : 572-575

Elsevier

Access to resources Recommend Favorite