The Study of Ingots and Deformed Semi-Finished Products of Al-Mg-Sc and Al-Cu-Li Alloys Using Diffraction Methods

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2016|877|471-476

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.877, 2017-01, pp. : 471-476

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

The influence of Al-Mg-Sc ingots and Al-Cu-Li semi-finished products heat treatment modes on structure, phase composition, and crystal structure was studied. Based on EBSD and EDS data, the difference of the sample microstructures was detected and the most favorable annealing mode for further deformation was presumed.

Related content

Physical Modeling Technological Regimes of Production Deformed Semi-Finished Products from Experimental Aluminium Alloys Alloyed by Scandium

By  

Materials Science Forum, Vol. 2018, Iss. 918, 2018-05 ,pp. : 54-62 (9)

Trans Tech Publications

Access to resources Recommend Favorite

Application and Research Twin Roll Casting-Extruding Process for Production Longish Deformed Semi-Finished Products from Aluminum Alloys

By  

Materials Science Forum, Vol. 2018, Iss. 918, 2018-05 ,pp. : 13-20 (8)

Trans Tech Publications

Access to resources Recommend Favorite

Role of Pre-Deformation on Aging Precipitation Behavior of Al-Cu-Li Alloys

By  

Materials Science Forum, Vol. 2016, Iss. 877, 2017-01 ,pp. : 180-187 (8)

Trans Tech Publications

Access to resources Recommend Favorite

Coarsening of cuboidal Al3Sc precipitates in an Al-Mg-Sc alloy

By Watanabe Chihiro  

Philosophical Magazine Letters, Vol. 90, Iss. 2, 2010-02 ,pp. : 103-111 (9)

Taylor & Francis Ltd

Access to resources Recommend Favorite

Eutectic isolation in Mg-Al-Cu-Li(-Y) alloys by centrifugal processing

By Löffler Jörg F.  

Philosophical Magazine, Vol. 83, Iss. 24, 2003-08 ,pp. : 2797-2813 (17)

Taylor & Francis Ltd

Access to resources Recommend Favorite