Effects of Si Content on the Tensile Strength and Machinability of Al-Mg-Si-Cu-Mn-Cr Alloys

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2016|877|141-146

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.877, 2017-01, pp. : 141-146

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effects of Mn and Cr Additions on the Recrystallization Behavior of Al-Mg-Si-Cu Alloys

By  

Materials Science Forum, Vol. 2016, Iss. 877, 2017-01 ,pp. : 172-179

Trans Tech Publications

Access to resources Recommend Favorite

Electron irradiation-enhanced core/shell organization of Al(Cr, Fe, Mn)Si dispersoids in Al–Mg–Si alloys

By Flament Camille   Ribis Joël   Garnier Jérôme   Vandenberghe Thierry   Henry Jean   Deschamps Alexis  

Philosophical Magazine, Vol. 95, Iss. 8, 2015-03 ,pp. : 906-917

Taylor & Francis Ltd

Access to resources Recommend Favorite

The effect of Cu on precipitation in Al-Mg-Si alloys

By Marioara C. D.  

Philosophical Magazine, Vol. 87, Iss. 23, 2007-08 ,pp. : 3385-3413

Taylor & Francis Ltd

Access to resources Recommend Favorite

The Influence of Cooling Rate on Microstructure, Tensile and Fatigue Behavior of Heat-Treated Al-Si-Cu-Mg Alloys

By  

Materials Science Forum, Vol. 2017, Iss. 884, 2017-02 ,pp. : 81-92

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Solution Treatment Temperature on Tensile Strength of Al-Mg-Si Alloy

By  

Materials Science Forum, Vol. 2015, Iss. 819, 2015-07 ,pp. : 39-44

Trans Tech Publications

Access to resources Recommend Favorite