Method Studied on the Tensile and Compression Strength Prediction of Friction Stir Welding Aircraft Panel

E-ISSN： 1662-9795|2016|723|142-147

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2016, Iss.723, 2017-02, pp. : 142-147

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Effects of tool tilt angle on tensile strength and fracture locations of friction stir welding of polyethylene

By Arici A. Selale S.

Science and Technology of Welding & Joining, Vol. 12, Iss. 6, 2007-08 ,pp. : 536-539

Maney Publishing

Access to resources Recommend Favorite

Tensile Strength and Metallurgical Analysis in Anodized Al/Cu Joint Using Friction Stir Welding

Key Engineering Materials, Vol. 2015, Iss. 656, 2015-08 ,pp. : 490-495

Trans Tech Publications

Access to resources Recommend Favorite

Thermoelectric method for temperature measurement in friction stir welding

By De Backer J Bolmsjö G

Science and Technology of Welding & Joining, Vol. 18, Iss. 7, 2013-10 ,pp. : 558-565

Maney Publishing

Access to resources Recommend Favorite

Development of high strength Ir based alloy tool for friction stir welding

By Miyazawa T Iwamoto Y Maruko T Fujii H

Science and Technology of Welding & Joining, Vol. 17, Iss. 3, 2012-04 ,pp. : 213-218

Maney Publishing

Access to resources Recommend Favorite

Development of friction stir welding of high strength steel sheet

By Matsushita M Kitani Y Ikeda R Ono M Fujii H Chung Y-D

Science and Technology of Welding & Joining, Vol. 16, Iss. 2, 2011-02 ,pp. : 181-187

Maney Publishing

Access to resources Recommend Favorite