Microstructure and Properties of Al-12.7Si-0.7Mg Alloy Extrusion after End-Quenching Test

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2016|879|1945-1950

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.879, 2017-02, pp. : 1945-1950

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of Hot Extrusion on Microstructure and Hardness of SiC Particle Reinforced Al-Zn-Mg-Cu Alloy Matrix Composite

By  

Materials Science Forum, Vol. 2015, Iss. 816, 2015-05 ,pp. : 118-125

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Mg and Cu Additions on Microstructure and Mechanical Properties of Squeeze Casting Al-Si-Cu-Mg Alloy

By  

Materials Science Forum, Vol. 2016, Iss. 850, 2016-04 ,pp. : 511-518

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Si Content of Matrix Alloy on the Microstructure and Properties of Sip/Al-Si-Mg Composites Prepared by Pressure Infiltration Method

By  

Materials Science Forum, Vol. 2017, Iss. 898, 2017-07 ,pp. : 992-999

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure and Mechanical Properties of Al-1.1Mg-0.6Si-0.4Cu Alloy Manufactured by Casting-Forging Integrated Technology

By  

Materials Science Forum, Vol. 2016, Iss. 850, 2016-04 ,pp. : 762-767

Trans Tech Publications

Access to resources Recommend Favorite

The Effects of Two-Stage Aging on the Microstructure and Mechanical Properties of the New Al-Si-Cu-Mg Alloy

By  

Materials Science Forum, Vol. 2016, Iss. 850, 2016-04 ,pp. : 581-586

Trans Tech Publications

Access to resources Recommend Favorite