Publisher： Edp Sciences
E-ISSN： 2261-236x|78|issue|01014-01014
ISSN： 2261-236x
Source： MATEC Web of conference, Vol.78, Iss.issue, 2016-10, pp. : 01014-01014
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
This paper proposes a new computational approach employed in obtaining optimal parameters of multi performances EDM. Regression and artificial neural network (ANN) are used as the modeling techniques meanwhile multi objective genetic algorithm (multiGA) is used as the optimization technique. Orthogonal array L256 is implemented in the procedure of network function and network architecture selection. Experimental studies are carried out to verify the machining performances suggested by this approach. The highest MRR value obtained from OrthoANN – MPR – MultiGA is 205.619 mg/min and the lowest Ra value is 0.0223μm.
Related content
Access to resources
Recommend
Multi-objective optimization approach for air traffic flow management
MATEC Web of conference, Vol. 105, Iss. issue, 2017-04 ,pp. :
Access to resources
Optimization of the machining parameters for EDM wire cutting of Tungsten Carbide
MATEC Web of conference, Vol. 57, Iss. issue, 2016-05 ,pp. :