Publisher: Edp Sciences
E-ISSN: 2100-014x|67|issue|02010-02010
ISSN: 2100-014x
Source: EPJ Web of Conference, Vol.67, Iss.issue, 2014-03, pp. : 02010-02010
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
This paper reports three sets of measurements of a single pulse impinging jet. The purpose is to serve as a reference for CFD validation. A gas injector generates a single pulse jet at Re ~90000. The jet impinges on a temperature controlled flat target at different angles (0º, 30º, 45º and 60º). The jet velocity field is measured with PIV. The evolution of the jet velocity profile in time is reported at two different locations (suitable as CFD inlet conditions). At the same locations also turbulence quantities are reported. The impingement wall temperature is measured with fast responding thermocouples and infrared camera. These give high time and space resolution respectively. Results are reported in a format suitable for comparison with CFD simulations. The results show that the heat transfer effects are highest for the jet impinging normally on the target. Target inclination has remarkable effects on the jet penetration rate and repeatability. Even small target inclinations result creates a preferential direction for the jet flow and cause a shift in the position of the stagnation region.
Related content
Heat transfer measurements and CFD simulations of an impinging jet
EPJ Web of Conference, Vol. 114, Iss. issue, 2016-03 ,pp. :
Turbulent heat transport and its anisotropy in an impinging jet
EPJ Web of Conference, Vol. 92, Iss. issue, 2015-05 ,pp. :