Damage modes of straight tungsten carbide in dry machining of titanium alloy TA6V

Publisher： Edp Sciences

E-ISSN： 1764-7177|134|issue|1265-1271

ISSN： 1155-4339

Source： Le Journal de Physique IV, Vol.134, Iss.issue, 2006-08, pp. : 1265-1271

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Related content

Experimental observations about the influence of the cuttingconditions in high speed machining of Ti-6Al-4V Titanium alloy

By  

Le Journal de Physique IV, Vol. 134, Iss. issue, 2006-08 ,pp. : 1273-1278

Edp Sciences

Access to resources Recommend Favorite

Surface roughness analysis after machining of direct laser deposited tungsten carbide

By  

Journal of Physics: Conference Series , Vol. 483, Iss. 1, 2014-03 ,pp. : 142-149

IOP Publishing

Access to resources Recommend Favorite

Deformation mechanisms of a commercial titanium alloy Ti6Al4V as afunction of strain rate and initial texture

By  

Le Journal de Physique IV, Vol. 134, Iss. issue, 2006-08 ,pp. : 845-850

Edp Sciences

Access to resources Recommend Favorite

Effect of heat treatment conditions on the dynamic strength and failure behavior of titanium alloy Ti-6Al-4V

By  

Le Journal de Physique IV, Vol. 134, Iss. issue, 2006-08 ,pp. : 1091-1096

Edp Sciences

Access to resources Recommend Favorite

On the optimisation of machining parameters for dry drilling of aeronautic aluminium alloy

By  

Le Journal de Physique IV, Vol. 110, Iss. issue, 2003-09 ,pp. : 471-476

Edp Sciences

Access to resources Recommend Favorite