Publisher： Edp Sciences
E-ISSN： 2261-236x|63|issue|01009-01009
ISSN： 2261-236x
Source： MATEC Web of conference, Vol.63, Iss.issue, 2016-07, pp. : 01009-01009
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
A new cold rotary forging technology of the internal helical involute spline was presented based on an analysis of the structure of automotive starter guide cylinder. 3D rigid-plastic finite element model was employed. Billet deformation, Billet equivalent stress and forming load were investigated under the DEFORM 3D software environment, then the forming process parameters were applied in the forming trials, and the simulation results are conformed with the experimental results. The validity of 3D finite element simulation model has been verified. The research results show that the proposed cold rotary forging technology can be efficient in handling of the forming manufacturing problems of automobile starter guide cylinder with internal helical involute spline.
Related content
Technology of slag processing by rotary cylinder at Baosteel
By Chengxiao Shen Yongqian Li Jiangang Wang Yin Liu
Revue de Métallurgie, Vol. 101, Iss. 1, 2010-03 ,pp. :
Access to resources
Recommend
Fatigue of automotive engine cylinder heads – A new model based on crack propagation
MATEC Web of conference, Vol. 165, Iss. issue, 2018-05 ,pp. :
Access to resources
New Challenges to the automotive fasteners and cold formed parts in the chinese markets
MATEC Web of conference, Vol. 21, Iss. issue, 2015-08 ,pp. :
Effect of rotational speed in rotary hammer forging process
MATEC Web of conference, Vol. 21, Iss. issue, 2015-08 ,pp. :