On the effect of boron on the mechanical properties of a new polycrystalline superalloy

E-ISSN： 2261-236x|14|issue|17003-17003

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.14, Iss.issue, 2014-08, pp. : 17003-17003

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Boron is used as a grain boundary strengthener in the nickel-based superalloys, but the reasons for its effect and the optimum quantities which need to be added are not well understood. Recently, some of the authors have developed a new corrosion-resistant single crystal superalloy for power generation applications which has a good balance of mechanical properties and resistance to environmental degradation. Here, this same alloy system is studied but in the polycrystalline state with additions of boron and carbon. The influence of boron on creep behaviour has been quantified and rationalised, with an emphasis on the grain boundary phase transformations which occur. NanoSIMS is utilised to investigate the segregation of boron at grain boundaries, with SEM used to characterise the effect of boron on the precipitation of Cr₂₃C₆ type carbides at grain boundaries. When the boron content increases, the agglomeration of M₂₃C₆ carbides at grain boundaries is inhibited. Uniformly distributed discrete M₂₃C₆ carbides are observed at higher boron content, whereas a deleterious film of M₂₃C₆ along the grain boundaries arises as the boron concentration is reduced. Boron promotes also the formation of γ′ layers at the grain boundaries.