Punching process including thickening of hole edge for improvement of fatigue strength of ultra-high strength steel sheet

Author： Kadarno Purwo Mori Ken-Ichiro Abe Yohei Abe Tatsuro

Publisher： Edp Sciences

E-ISSN： 2265-4224|1|issue|4-4

ISSN： 2265-4224

Source： Manufacturing Review, Vol.1, Iss.issue, 2014-05, pp. : 4-4

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Hot semi-punching and cold scrap removing processes for hot stamping of ultra-high strength steel parts

By Mori Ken-ichiro Maeno Tomoyoshi Suganami Takuya

Manufacturing Review, Vol. 2, Iss. issue, 2015-05 ,pp. : 11-11

Edp Sciences

Access to resources Recommend Favorite

Current situation and properties of ultra-high strength steel for automotive use in Japan

By Yamazaki K.

Revue de Métallurgie, Vol. 100, Iss. 7-8, 2010-03 ,pp. : 779-786

Edp Sciences

Access to resources Recommend Favorite

The influence of tension mean stress to the crack initiation process at the very high cycle fatigue regime for a high strength steel

By Rohm Thomas

MATEC Web of conference, Vol. 165, Iss. issue, 2018-05 ,pp. : 20001-20001

Edp Sciences

Access to resources Recommend Favorite

Fatigue behavior of 590MPa Tensile Strength galvanneal coated sheet steel laser welded blanks

By Bhat Shrikant P.

MATEC Web of conference, Vol. 165, Iss. issue, 2018-05 ,pp. : 21001-21001

Edp Sciences

Access to resources Recommend Favorite

Experimental investigation of the effects of process parameters on the strength of eutectoid steel (AISI 1075) sheet resistance spot welds

By Safari Mehdi Mostaan Hosein

Metallurgical Research & Technology (formerly Revue de Métallurgie), Vol. 113, Iss. 3, 2016-04 ,pp. : 305-305

Edp Sciences

Access to resources Recommend Favorite