Investigation of Conditions of Processing Influence on Micro-Hardness Distribution in Surface Layer during Diamond Burnishing of Samples of FeC0.15Cr12Ni2 Steel

Publisher: Trans Tech Publications

E-ISSN: 1662-9795|2017|746|290-295

ISSN: 1013-9826

Source: Key Engineering Materials, Vol.2017, Iss.746, 2017-08, pp. : 290-295

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

The article shows the results of experimental investigation influence of process conditions on parameters, defining plastic deformation, during diamond burnishing process: maximum of micro-hardness and depth of hardened layer (depth of workhardening). Empirical dependences, linking the maximum of micro-hardness and depth of workhardening to the diamond burnishing process parameters, were obtained on the base of the experimental investigation.