An Investigation into the Dependency of Cutting Forces on the Volume Fraction and Fibre Orientation during Machining Composite Materials

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2017|882|61-65

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2017, Iss.882, 2017-02, pp. : 61-65

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Discrete Element Simulation of Machining Cracks in Brittle Materials during High Speed Cutting

By  

Materials Science Forum, Vol. 2016, Iss. 836, 2016-02 ,pp. : 117-125

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Fibre Taper on the Interfacial Shear Stress in Fibre-Reinforced Composite Materials during Elastic Stress Transfer

By Goh K.L.  

Composite Interfaces, Vol. 17, Iss. 1, 2010-01 ,pp. : 74-80

Taylor & Francis Ltd

Access to resources Recommend Favorite

Edge Cutting Tools for Machining of Hard-to-Cut Materials

By  

Materials Science Forum, Vol. 2016, Iss. 857, 2016-06 ,pp. : 213-220

Trans Tech Publications

Access to resources Recommend Favorite

Investigation of cutting forces by the method of statistical planning of the experiment

By Sagradyan A.  

Journal of Engineering Physics and Thermophysics, Vol. 78, Iss. 5, 2005-09 ,pp. : 1034-1039

Springer Publishing Company

Access to resources Recommend Favorite

TEM investigation of wear mechanisms during metal machining

By Ruppi S.   Halvarsson M.  

Thin Solid Films, Vol. 353, Iss. 1, 1999-09 ,pp. : 182-188

Elsevier

Access to resources Recommend Favorite