Influence of Initial Microstructure on the Hot Working Flow Stress of Mg-3Al-1Zn Alloy

E-ISSN： 1662-9752|2017|898|86-90

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2017, Iss.898, 2017-07, pp. : 86-90

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of Hot Extrusion on Microstructure and Hardness of SiC Particle Reinforced Al-Zn-Mg-Cu Alloy Matrix Composite

Materials Science Forum, Vol. 2015, Iss. 816, 2015-05 ,pp. : 118-125

Trans Tech Publications

Access to resources Recommend Favorite

Mechanical Properties and Microstructure of the Magnesium Alloy Mg-6.8Y-2.5Zn-0.5Al Produced by Casting and Hot Rolling

Materials Science Forum, Vol. 2018, Iss. 918, 2018-05 ,pp. : 3-12

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure Evolution of the Mg-3Zn-0.5Er Alloy during Hot Rolling

Materials Science Forum, Vol. 2017, Iss. 898, 2017-07 ,pp. : 118-123

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure Evolution and Mechanical Properties of Mg-3Zn-0.5Er-0.5Al Alloy

Materials Science Forum, Vol. 2015, Iss. 816, 2015-05 ,pp. : 446-450

Trans Tech Publications

Access to resources Recommend Favorite

Improving the Microstructure and Mechanical Properties of a Cast Mg-9Al-1Zn Alloy Using Friction Stir Processing

Materials Science Forum, Vol. 2016, Iss. 838, 2016-02 ,pp. : 214-219

Trans Tech Publications

Access to resources Recommend Favorite