Temperature Distribution in the Machining Zone during the Turning of a Shaft Made of the AMS5643 Steel

E-ISSN： 1662-9779|2017|261|58-65

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2017, Iss.261, 2017-09, pp. : 58-65

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Turning and drilling of parts made from sinter hardenable steel powders

By Blais C. L'Espérance G.

Powder Metallurgy, Vol. 45, Iss. 1, 2002-02 ,pp. : 39-47

Maney Publishing

Access to resources Recommend Favorite

Hot Re-pressing of Powder Made from Mild Steel Machining Swarf

By Lengyel B. Tan C. L. Teh G. G.

Powder Metallurgy, Vol. 19, Iss. 3, 1976-01 ,pp. : 134-140

Maney Publishing

Access to resources Recommend Favorite

Finite Element Modelling of the effect of tool rake angle on tool temperature and cutting force during high speed machining of AISI 4340 steel

IOP Conference Series: Materials Science and Engineering, Vol. 50, Iss. 1, 2013-12 ,pp. : 309-314

IOP Publishing

Access to resources Recommend Favorite

Prediction of hardness distribution in steel heat affected zone

By Kasuya T. Hashiba Y.

Science and Technology of Welding & Joining, Vol. 4, Iss. 5, 1999-10 ,pp. : 265-275

Maney Publishing

Access to resources Recommend Favorite

Estimation of Local Plastic Deformation in Cutting Zone during Turning

Key Engineering Materials, Vol. 2015, Iss. 662, 2015-10 ,pp. : 173-176

Trans Tech Publications

Access to resources Recommend Favorite