A Method for the Determination of Theoretical Roughness in Face Milling Considering the Run-Out of the Inserts

E-ISSN： 1662-9779|2017|261|251-258

ISSN： 1012-0394

Source： Solid State Phenomena, Vol.2017, Iss.261, 2017-09, pp. : 251-258

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Roughness profile in high speed face milling operation

By Louati H. Bouzid W.

Materials Technology: Advanced Performance Materials, Vol. 23, Iss. 4, 2008-12 ,pp. : 231-237

Maney Publishing

Access to resources Recommend Favorite

Surface Roughness Prediction in Face Milling by Special Tools

Key Engineering Materials, Vol. 2016, Iss. 686, 2016-03 ,pp. : 161-167

Trans Tech Publications

Access to resources Recommend Favorite

Comparison of Theoretical and Real Surface Roughness in Case of Ball-End Milling

Solid State Phenomena, Vol. 2017, Iss. 261, 2017-09 ,pp. : 299-304

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Micro End Mill Tool Run-Out on Machining Accuracy

Key Engineering Materials, Vol. 2017, Iss. 749, 2017-09 ,pp. : 21-26

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Lead Angle Variation on the Coated Carbide Inserts Wear when Milling CGI and Modeling by Artificial Neural Networks and Regression Analysis Method

Solid State Phenomena, Vol. 2015, Iss. 220, 2015-01 ,pp. : 595-9

Trans Tech Publications

Access to resources Recommend Favorite