Author: Dong Hua Zhang Hongzhi Zuo Yibing Gao Peng Ye Guang
Publisher: MDPI
E-ISSN: 1996-1944|11|2|201-201
ISSN: 1996-1944
Source: Materials, Vol.11, Iss.2, 2018-01, pp. : 201-201
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Mercury intrusion porosimetry (MIP) measurements are widely used to determine pore throat size distribution (PSD) curves of porous materials. The pore throat size of porous materials has been used to estimate their compressive strength and air permeability. However, the effect of sample size on the determined PSD curves is often overlooked. In pursuit of a better understanding of the effect of sample size on mercury intrusion into porous materials, a combined experimental and numerical approach was applied. Quartz sand and epoxy resin were mixed to form artificial sandstone. Digital microstructures of the sandstone were obtained by using X-ray computed tomography (CT scan) technique. PSD curves of the artificial sandstone with different sample sizes were determined both by MIP measurement and by simulation of mercury intrusion (i.e., MIP simulation). Percolation analysis was performed on mercury-intruded pores in the digital microstructures. The PSD curves determined both by MIP measurements and by MIP simulations show that there was a significant effect of sample size on mercury intrusion before percolation of mercury-intruded pores. The effect of sample size decreased with the increasing pressure. After the mercury-intruded pores percolated through the samples, the effect of sample size on mercury intrusion became minor. The pore throat size of the artificial sandstone was used to estimate the air permeability using the relation proposed in the literature. The calculated air permeability of the smaller sandstone sample was higher. However, in principle, the air permeability of sandstone samples should be independent of the sample size. Two main conclusions can be drawn: (1) a fixed sample size should be used in MIP measurements or MIP simulation so that the PSD curves of different samples can be properly compared, (2) sample size needs to be considered when the pore throat size determined by MIP measurement is used for estimating air permeability.
Related content
4.1.1. Mercury Intrusion Porosimetry
Polymers Research Journal, Vol. , Iss. , 2016-07 ,pp. :
By Kudr Jiri Nguyen Hoai Viet Gumulec Jaromir Nejdl Lukas Blazkova Iva Ruttkay-Nedecky Branislav Hynek David Kynicky Jindrich Adam Vojtech Kizek Rene
Sensors, Vol. 15, Iss. 1, 2014-12 ,pp. :