Chatter identification in milling of Inconel 625 based on recurrence plot technique and Hilbert vibration decomposition

Publisher： Edp Sciences

E-ISSN： 2261-236x|148|issue|09003-09003

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.148, Iss.issue, 2018-02, pp. : 09003-09003

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

An orthogonal technique for empirical mode decomposition in Hilbert-Huang transform

By Lou Menglin  

MATEC Web of conference, Vol. 24, Iss. issue, 2015-10 ,pp. : 03004-03004

Edp Sciences

Access to resources Recommend Favorite

Wave attenuation effects on the chatter instability of end-milling

By Ozoegwu C.G.   Omenyi S.N.  

Noise Control Engineering Journal, Vol. 61, Iss. 4, 2013-07 ,pp. : 436-444

Institute of Noise Control Engineering

Access to resources Recommend Favorite

An investigation on the cutting force of milling Inconel 718

By Tsai Jhy-Cherng  

MATEC Web of conference, Vol. 169, Iss. issue, 2018-05 ,pp. : 01039-01039

Edp Sciences

Access to resources Recommend Favorite

Bearing fault detection using motor current signal analysis based on wavelet packet decomposition and Hilbert envelope

By Imaouchen Yacine  

MATEC Web of conference, Vol. 20, Iss. issue, 2015-01 ,pp. : 03002-03002

Edp Sciences

Access to resources Recommend Favorite

Damage identification in beams by a response surface based technique

By Teidj S.  

MATEC Web of conference, Vol. 16, Iss. issue, 2014-09 ,pp. : 10006-10006

Edp Sciences

Access to resources Recommend Favorite