ZrO₂ Pre-Sintered Blocks (3%mol-Y₂O₃) with Color Gradient for Dental Prostheses

E-ISSN： 1662-9752|2018|930|57-62

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2018, Iss.930, 2018-10, pp. : 57-62

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

In dentistry, metal-free ceramic systems are used to improve optical properties in dental restorations. Ceramics based on tetragonal zirconia ZrO₂-Y₂O₃ are used in the manufacturing of dental prostheses for being biocompatible and for presenting proper mechanical and optical properties. Most of tetragonal zirconia blocks are commercialized in one only hue, which difficult the achievement of high aesthetic performance due to the tooth’s polychromatic characteristics. This work proposes to obtain tetragonal zirconia blocks fabricated by uniaxial cold pressing in different hues which could provide ceramic prostheses with better aesthetic results in less time. Zirconia blocks in two different colors were produced and characterized for their physical properties and mechanical resistance. The colors difference between the layers was obtained by using different amounts of Fe₂O₃. Ceramics with relative density superior to 99% were obtained by sintering the materials at 1530oC for 120 minutes. The mechanical properties evaluated indicated hardness close to 1270HV and fracture toughness of 7MPa.m^1/2. Blocks with different hues may be an alternative in order to favor the aesthetics in the cervical region and decrease the amount of ceramic veneering.