Management of space orientation of the end effector of generation of geometry system fiveaxis manufacturing machinery for additive generation of geometry

Publisher： Edp Sciences

E-ISSN： 2261-236x|226|issue|01004-01004

ISSN： 2261-236x

Source： MATEC Web of conference, Vol.226, Iss.issue, 2018-11, pp. : 01004-01004

Access to resources Favorite

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

The article is devoted to the investigation of the surface layer formation accuracy of engineering products by additive methods. The analysis of advantages and disadvantages of layered products synthesis technologies was carried out. It was revealed that, in additive shaping, the exact characteristics of the surface layer differ significantly from the accuracy characteristics of the surface layer of products obtained by the traditional methods. The analysis of domestic and foreign works on the topic of research was carried out. It is revealed that to increase the accuracy characteristics of products obtained by additive methods, it is necessary to realize dynamically the spatial orientation of the working element of the additive installation in the process of shaping. To control the spatial orientation of the working organ of additive equipment, a method is proposed. According to the proposed method, the controlled parameters of the additive installation are calculated on the basis of a 5- coordinate mechatronic system. The proposed methodology will allow to calculate the controlled parameters of the process equipment, to provide the required orientation of the working element of the additive installation to reduce the error of shaping (approximation), using 5-coordinate mechatronic system