Effects of Process Parameters on the Shape Changes of a Micro Cementite Band during Macro Drawing of a Pearlitic Steel Wire

Publisher： Trans Tech Publications

E-ISSN： 1662-9795|2018|792|41-46

ISSN： 1013-9826

Source： Key Engineering Materials, Vol.2018, Iss.792, 2019-01, pp. : 41-46

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

This paper is concerned with the effects of process parameters on the shape changes of a micro cementite band in wire drawing of pearlitic steel. Two process parameters, an initial orientation of cementite band and its location, are chosen. In this study, a macro deformation behavior at a material point in macro wire drawing of pearlitic steel is represented by an averaged behavior of a unit model. This unit model is simulated by a micro finite element analysis, while a macro wire drawing of pearlitic steel is simulated by finite element method at a continuum scale. The shape changes of a cementite band would be traced, by solving the unit problem with the changes of boundary conditions corresponding to the macro deformation behaviors of material points along a particle path. The predicted shapes of cementite bands are compared to those by the experiments reported in the literature. Qualitative comparisons between the current predictions and experiments verify the proposed method. Effects of an initial orientation of cementite band and its location on its shpae changes are presented. It was also noted that the most micro deformation in a unit model occurs in the deformation zone.