Simultaneous Prediction of Bendability and Deep Drawability Based on Orientation Distribution Function for Polycrystalline Cubic Metal Sheets

Publisher： Trans Tech Publications

E-ISSN： 1662-9752|2018|941|1468-1473

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2018, Iss.941, 2019-01, pp. : 1468-1473

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Experimental Investigation of Temperature Distribution during Wire-Based Laser Metal Deposition of the Al-Mg Alloy 5087

By  

Materials Science Forum, Vol. 2018, Iss. 941, 2019-01 ,pp. : 988-994

Trans Tech Publications

Access to resources Recommend Favorite

Bendability of Shot Blasted Ultrahigh-Strength Steels

By  

Materials Science Forum, Vol. 2018, Iss. 941, 2019-01 ,pp. : 510-515

Trans Tech Publications

Access to resources Recommend Favorite

Microstructure-Dependent Deform Behavior of a Polycrystalline Ni-Based Superalloy Based on Micropillar Compression

By  

Materials Science Forum, Vol. 2019, Iss. 944, 2019-02 ,pp. : 25-32

Trans Tech Publications

Access to resources Recommend Favorite

Limit Strains Analysis of Advanced High Strength Steels Sheets Based on Surface Roughness Measurements

By  

Materials Science Forum, Vol. 2018, Iss. 930, 2018-10 ,pp. : 349-355

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Tempering on Bendability and Impact Property of Hot Rolled Low-Carbon Martensitic Steel

By  

Materials Science Forum, Vol. 2018, Iss. 941, 2019-01 ,pp. : 474-479

Trans Tech Publications

Access to resources Recommend Favorite