![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
Publisher: Trans Tech Publications
E-ISSN: 1662-7482|2014|704|70-76
ISSN: 1660-9336
Source: Applied Mechanics and Materials, Vol.2014, Iss.704, 2015-02, pp. : 70-76
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Related content
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
PARAMETRIC INFLUENCE AND OPTIMIZATION OF WIRE EDM OF HOT DIE STEEL
Machining Science and Technology, Vol. 15, Iss. 1, 2011-01 ,pp. :
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
An Investigation of Machining Time and Surface Roughness in Wire-EDM for Inconel 800
Applied Mechanics and Materials, Vol. 2015, Iss. 789, 2015-10 ,pp. :
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
Thermal Modeling and Structural Analysis in Wire EDM Process for a 3D Model
Applied Mechanics and Materials, Vol. 2016, Iss. 852, 2016-10 ,pp. :
![](/images/ico/ico_close.png)
![](/images/ico/ico5.png)
A Research on a Medium-Speed Wire Cut Electrical Discharge Machining
Applied Mechanics and Materials, Vol. 2014, Iss. 711, 2015-02 ,pp. :