Corrosion of High Zn Content Al-Zn-Mg-Cu Alloy in 3.5 wt.% NaCl Solution

E-ISSN： 1662-7482|2014|703|21-28

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2014, Iss.703, 2015-01, pp. : 21-28

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Stress Corrosion Cracking Behaviour of Flux Bounded TIG Welded AA2219 T87 Aluminum Alloy in 3.5 Weight Percent NaCl Solution

Applied Mechanics and Materials, Vol. 2015, Iss. 766, 2015-07 ,pp. : 733-738

Trans Tech Publications

Access to resources Recommend Favorite

Effects of Cu Addition on the Precipitation Process of Al-9Zn-4Mg-xCu (wt. %) Alloys at 130°C

Applied Mechanics and Materials, Vol. 2016, Iss. 835, 2016-06 ,pp. : 222-229

Trans Tech Publications

Access to resources Recommend Favorite

Electrochemical Impedance Behavior of Various Composition Quaternary Ni Alloy in 3.5 Wt% NaCl

Applied Mechanics and Materials, Vol. 2015, Iss. 761, 2015-06 ,pp. : 407-411

Trans Tech Publications

Access to resources Recommend Favorite

Effect of Surface Strengthening on Corrosion Property of Ti-6Al-4V in 3.5% NaCl

Applied Mechanics and Materials, Vol. 2016, Iss. 853, 2017-01 ,pp. : 473-477

Trans Tech Publications

Access to resources Recommend Favorite

High Cycle Fatigue Properties of Duplex Stainless Steel in Air and 3.5% NaCl Solution

Applied Mechanics and Materials, Vol. 2015, Iss. 750, 2015-05 ,pp. : 114-120

Trans Tech Publications

Access to resources Recommend Favorite