

Publisher: Trans Tech Publications
E-ISSN: 1662-7482|2015|735|205-209
ISSN: 1660-9336
Source: Applied Mechanics and Materials, Vol.2015, Iss.735, 2015-04, pp. : 205-209
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
The aim of this research is to investigate addition of iron (ferric chloride) to control of sulphate reduction in order to enhance the methane production under laboratory scale. The bioreactor Upflow Anaerobic Sludge Blanket (UASB) undergoes continuous operation under anaerobic condition treating synthetic sulphate enriched wastewater. The wastewater used as influent wastewater with a total COD 8000 mg.L-1. The experiment was conducted for about 64 days and was operated at constant OLR of 2.0(±0.1) kgCOD.m-3.d-1 by maintaining a hydraulic retention time (HRT) of 4 days. The UASB then were feed with sulphate and give the COD/SO4 ratio 5.3, 2.5 and 1.5. Then amount of ferric chloride at 10.4, 22.2 and 44.5 mM was introduce just after methane producing bacteria (MPB) were completely inhibited by sulphate reducing bacteria (SRB) due to decreasing of methane composition (CH4) and high level production of hydrogen sulphide (H2S). The obtained results showed that the FeCl3 negatively impacted the anaerobic digestion process since with each of COD/SO42- ratio, and the amount addition of ferric chloride to feed regime, gives promotion on methane production, with 67, 70 and 69% after approximately 10 to 15 days operating at critical conditions.
Related content


The Application of Fuzzy Control in Vehicle Emission Reduction Technology
Applied Mechanics and Materials, Vol. 2015, Iss. 719, 2015-02 ,pp. :


Magneto-Rheological Vibration Reduction Control and ARM Realization
Applied Mechanics and Materials, Vol. 2015, Iss. 738, 2015-04 ,pp. :




A Study on Outdoor SVG Overheat Capacity Reduction Control Strategy
Applied Mechanics and Materials, Vol. 2014, Iss. 716, 2015-02 ,pp. :


Optimal Control Strategy at the Main Reduction Process for Lunar Spacecraft Soft Landing
Applied Mechanics and Materials, Vol. 2015, Iss. 775, 2015-08 ,pp. :