

Publisher: Trans Tech Publications
E-ISSN: 1662-7482|2015|743|233-238
ISSN: 1660-9336
Source: Applied Mechanics and Materials, Vol.2015, Iss.743, 2015-05, pp. : 233-238
Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.
Abstract
Microstrip filter has extensive application in microwave circuit and communication system in the future. We take lumped components low-pass filter as the prototype and employ the Richards transformation and the Kuroda rule to change the low pass prototype into a bandstop filter. By using ADS (Advanced Design System) method we design a microstrip stub bandstop filter, whose center frequency, range of frequency and relative width are respectively 4GHz, 3GHz ~ 5GHz and 8%. And then we further optimize the parameters to get the circuit design layout. It is shown that all indexes reach the design requirements and the method possesses the features such as short period and high reliability.
Related content


Design of Compact Composite Microstrip Low Pass Filter Using MEMS Technology
Applied Mechanics and Materials, Vol. 2015, Iss. 754, 2015-05 ,pp. :


Design of a 2-Stage Broadband Low Noise Amplifier Based on the Agilent ADS
Applied Mechanics and Materials, Vol. 2015, Iss. 719, 2015-02 ,pp. :


Design of a 2.4GHz-Microstrip Line Filter Using the Semicircle Defected Ground Structure
Applied Mechanics and Materials, Vol. 2018, Iss. 876, 2018-03 ,pp. :


Design of an Ideal Low Pass Microstrip Line Filter Using the Defected Ground Structure
Applied Mechanics and Materials, Vol. 2018, Iss. 876, 2018-03 ,pp. :


A Filter Design Method Based on Combination Wavelets
Mechanical Systems and Signal Processing, Vol. 11, Iss. 5, 1997-09 ,pp. :