Verification of External Gas-Assisted Mold Temperature Control for Injection Molding Process

E-ISSN： 1662-7482|2015|752|949-954

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.752, 2015-05, pp. : 949-954

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Computer Aided Injection Multi Cavity Molding Process Analysis of Thermoplastic Polymers

Applied Mechanics and Materials, Vol. 2015, Iss. 808, 2015-12 ,pp. : 107-112

Trans Tech Publications

Access to resources Recommend Favorite

Numerical Optimization of Shrinkage and Warpage on the Injection Molding Process Parameters of Electrical Connector

Applied Mechanics and Materials, Vol. 2017, Iss. 868, 2017-08 ,pp. : 183-191

Trans Tech Publications

Access to resources Recommend Favorite

Processing Temperature of Sustainable Polymer with Thermoplastics by Injection Molding (Part 2)

Applied Mechanics and Materials, Vol. 2015, Iss. 789, 2015-10 ,pp. : 85-89

Trans Tech Publications

Access to resources Recommend Favorite

Fracture Parameters of Short Carbon Fiber Reinforced Polycarbonate Composite Fabricated by Injection Molding Process

Applied Mechanics and Materials, Vol. 2015, Iss. 776, 2015-08 ,pp. : 186-192

Trans Tech Publications

Access to resources Recommend Favorite

Optimization of Cable Ties Injection Molding Process Using Back Propagation Neural Network and Genetic Algorithm (BPNN-GA)

Applied Mechanics and Materials, Vol. 2016, Iss. 836, 2016-07 ,pp. : 159-164

Trans Tech Publications

Access to resources Recommend Favorite