Calculation of the Heat Content of the Electrode Metal Droplet When Applying Power Supplies for Manual Arc Welding with Different Volt-Ampere Characteristic

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|756|101-104

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.756, 2015-05, pp. : 101-104

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Increasing Efficiency by Applying the Arc Covered-Electrode Welding for Repairing Magnetized Pipelines

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 756, 2015-05 ,pp. : 132-136

Trans Tech Publications

Access to resources Recommend Favorite

Electronic Circuit Design of Power Supplies for Welding in Ltspice Iv Program

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 770, 2015-07 ,pp. : 323-327

Trans Tech Publications

Access to resources Recommend Favorite

Weld Properties of Low Carbon Steel Using Shielded Metal Arc Welding

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 486-490

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Stick-Slip Effect on Gas Metal Arc Welding

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 813, 2015-12 ,pp. : 438-445

Trans Tech Publications

Access to resources Recommend Favorite

Identification of Optimized Welding Conditions for Pulsed Current Gas Metal Arc Welding of AISI 904 Super Austenitic Stainless Steel

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 500-504

Trans Tech Publications

Access to resources Recommend Favorite