Some Considerations Regarding Micro Hardness of Parts Manufactured from 316-L Steel Using SLM Technology

Publisher： Trans Tech Publications

E-ISSN： 1662-7482|2015|760|515-520

ISSN： 1660-9336

Source： Applied Mechanics and Materials, Vol.2015, Iss.760, 2015-06, pp. : 515-520

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Influence of Layer Thickness on Internal Structure of Parts Manufactured from 316-L Steel Using SLM Technology

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 369-374

Trans Tech Publications

Access to resources Recommend Favorite

Experimental Investigation of Machining Parameters during Turning of AISI 316L Stainless Steel Using Nano Cutting Environment

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 787, 2015-09 ,pp. : 361-365

Trans Tech Publications

Access to resources Recommend Favorite

Improved Surface Integrity during End Milling AISI 316L Stainless Steel Using Heat Assisted Machining

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 752, 2015-05 ,pp. : 62-67

Trans Tech Publications

Access to resources Recommend Favorite

Indirect Selective Laser Sintering of 316L Powder and the Properties of the Parts

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 775, 2015-08 ,pp. : 209-213

Trans Tech Publications

Access to resources Recommend Favorite

Impact Properties of Parts Manufactured from Fiberglass and Kevlar Composite Panels

By  

Applied Mechanics and Materials, Vol. 2015, Iss. 809, 2015-12 ,pp. : 938-943

Trans Tech Publications

Access to resources Recommend Favorite