Densification of quartz powder and reduction of conductivity at 700°C

E-ISSN： 2156-2202|100|B7|13081-13092

ISSN： 0148-0227

Source： Journal Of Geophysical Research, Vol.100, Iss.B7, 1995-07, pp. : 13081-13092

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

We have measured axial strain, volumetric strain, and electrical conductivity during the densification at 700°C of ultra‐fine quartz powder (5–10 μm diameter) saturated with distilled water. Individual experiments were run at confining pressures ranging from 200 to 370 MPa and pore pressures of 30, 100, and 200 MPa. During the experiments, which lasted from 10 hours to 8 days, the porosity decreased from an initial value of about 40% to final porosities ranging from 19% to as little as 8±1%. In all experiments, initial volumetric compaction rates were rapid (10⁻⁵ to 10⁻⁶ s⁻¹) but decreased to between 10⁻⁷ and 10⁻⁸ s⁻¹ after approximately 1 day. Electrical conductivity also decreased monotonically from 10⁻² to 10⁻⁴ S/m during the experiments. We present a model in which changes in conductivity are controlled by constrictions in interconnecting channels, while porosity is controlled primarily by deposition of quartz in the pores. Both experimental and model results suggest a densification process in which conductivity reduces to matrix conductivity while leaving a residual porosity of 3–5%. In the Earth, the porosity at a given instant will be the net resultant of porosity reducing processes and porosity producing processes including fracturing. The rapid loss of conductivity and, by inference, permeability suggests that in the absence of processes which increase permeability, both of these properties should have very small values in the lower crust. Furthermore, these experiments lend support to arguments that time‐dependent compaction of fault gouge can play an important role in modifying fluid pressure and fault strength during the interseismic portion of the earthquake cycle for large earthquakes.