A Review on Fabricating Procedures in Rapid Prototyping

Publisher： IGI Global_journal

E-ISSN： 2156-1672|6|2|23-40

ISSN： 2156-1680

Source： International Journal of Manufacturing, Materials, and Mechanical Engineering (IJMMME), Vol.6, Iss.2, 2016-04, pp. : 23-40

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Rapid Prototyping as a Tool of Fabricating Biomodel in Medical Applications: Technique and Cost Evaluation

By  

Advanced Materials Research, Vol. 2015, Iss. 1115, 2015-08 ,pp. : 627-630

Trans Tech Publications

Access to resources Recommend Favorite

A three dimensional model for direct laser metal powder deposition and rapid prototyping

By Labudovic M.   Hu D.   Kovacevic R.  

Journal of Materials Science, Vol. 38, Iss. 1, 2003-01 ,pp. : 35-49

Springer Publishing Company

Access to resources Recommend Favorite

Fabrication of PDMS Microfluidic via Room Temperature Rapid Prototyping Process

By  

Advanced Materials Research, Vol. 2015, Iss. 1109, 2015-07 ,pp. : 340-344

Trans Tech Publications

Access to resources Recommend Favorite

Influence of process parameters on the surface roughness in hotwire cutting of EPS foam sheet for VLM-S rapid prototyping process

By Ahn Dong-Gyu   Lee Sang-Ho   Yang Dong-Yol  

Journal of Materials Science, Vol. 40, Iss. 21, 2005-11 ,pp. : 5699-5702

Springer Publishing Company

Access to resources Recommend Favorite

Scaffolds for bone tissue engineering fabricated from two different materials by the rapid prototyping technique: PCL versus PLGA

By Park So  

Journal of Materials Science: Materials in Medicine, Vol. 23, Iss. 11, 2012-11 ,pp. : 2671-2678

Springer Publishing Company

Access to resources Recommend Favorite