Analysis of Aluminum Extrusion in a 90^o Die by Finite Volume Method

E-ISSN： 1662-8985|2016|1135|153-160

ISSN： 1022-6680

Source： Advanced Materials Research, Vol.2016, Iss.1135, 2016-02, pp. : 153-160

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Nowadays, the finite element method is still the first choice of researchers in metal extrusion analysis. However, recent published papers have also supported that metal plastic flow can be modelled by the flow formulation, employing the finite volume method. In this work, the numerical scheme presented by Martins et al. [16] based on finite volume method together with the explicit MacCormack numerical method, was used to analyse aluminum axisymmetric direct extrusion in a 90° die. A structured, fixed and collocated mesh and numerical convergence based on the SIMPLE method were employed to attain pressure-velocity coupling. The main goal of present numerical scheme was to obtain the axial and radial velocities and pressure distributions. From these results, it was possible to obtain and identify the dead zone inside the billet deformation region in direct extrusion of aluminum in a 90° die. The field variables results shown in present work had good agreement when compared with those from literature.