Research on the Tool Wear Mechanism of Cemented Carbide Ball End Mill Machining Titanium Alloy

E-ISSN： 1662-9752|2016|836|318-325

ISSN： 0255-5476

Source： Materials Science Forum, Vol.2016, Iss.836, 2016-02, pp. : 318-325

Disclaimer: Any content in publications that violate the sovereignty, the constitution or regulations of the PRC is not accepted or approved by CNPIEC.

Previous Menu Next

Abstract

Related content

Characteristic of Tool Wear in Small End Milling of Nickel-Titanium Alloy

Materials Science Forum, Vol. 2016, Iss. 874, 2016-11 ,pp. : 429-432

Trans Tech Publications

Access to resources Recommend Favorite

Influence of Carbide Substrate Properties on Wear Resistance of Tool with Multilayer Coating in Machining of Chromium-Based Heat-Resistant Alloy

Materials Science Forum, Vol. 2016, Iss. 876, 2016-11 ,pp. : 59-68

Trans Tech Publications

Access to resources Recommend Favorite

Adhering wear mechanism of cemented carbide cutter in the intervallic cutting of stainless steel

By Sun F. Li Z. Chen B. Jiang D.

Wear, Vol. 214, Iss. 1, 1998-01 ,pp. : 79-82

Elsevier

Access to resources Recommend Favorite

Effect of carbide fraction and matrix microstructure on the wear of cast iron balls tested in a laboratory ball mill

By Albertin E. Sinatora A.

Wear, Vol. 250, Iss. 1, 2001-10 ,pp. : 492-501

Elsevier

Access to resources Recommend Favorite

Carbide tool wear mechanism in turning of Inconel 718 superalloy

By Liao Y.S. Shiue R.H.

Wear, Vol. 193, Iss. 1, 1996-04 ,pp. : 16-24

Elsevier

Access to resources Recommend Favorite